Filter
Top Products
8-1
8 PARAMETERS SETTING MODE
8 PARAMETERS SETTING MODE
8.1 Parameter Setting Options
8.1.1 Parameters for Measurement and Display
Menu Selecting Item Contents
Ang. Unit deg / gon / mil
Select degree(360°), gon(400G) or mil (6400M) for the
measuring angle unit to be shown on the display.
Min.Angle OFF / ON
Select the minimum display angle reading ON or OFF.
GTS-821A [ OFF:1" / ON:0.5" ]
GTS-822A [ OFF:1" / ON:0.5" ]
GTS-823A [ OFF:5" / ON:1" ]
GTS-825A [ OFF:5" / ON:1" ]
Tilt OFF / 1axis / 2axes
Select the tilt sensor option for OFF, (1axis) vertical only or
(2axes) vertical and horizontal.
Err. corr. OFF / ON
Select the error correction ON or OFF for collimation and error
adjustment.
Note
:
Perform this item after complete section 9.4.
For more information, refer to Section 9.4 “Adjustment of
Compensation Systematic Error of Instrument” and Section
9.5 “Showing Constant List and Switch ON/OFF
Compensation Systematic Error of Instrument” .
V -0 Zenith / Level Select the vertical angle reading for Zenith 0 or Horizontal 0.
HAmem OFF / MEM. ON
It is able to retain presetting angle after turning power
off.(MEMORY)
Note
:
After changing this parameter, turn the power switch off once.
Turn
Fine / Normal /
Coarse
Select the stopping accuracy of automatic rotation to required
angle.
Fine:3" Normal :5" Coarse:10"
Auto.Aim
Fine / Normal /
Coarse
Select the accuracy of automatic collimation.
Prog
Std
Mem Comm
Adj
Para
2003-10-10 15:30:40
PARAMETERS SETTING MODE
[Press [F6] key.]
In this mode, setting of parameters regard with measuring, displaying and
communications will be done.
When a parameter is changed and set, the new value is stored into memory.
Press [F6] key from the main menu icons, the following display will be shown.
The parameter modes is classified in Measurement and Communication.
Parameters
F1 Measurement
F2 Communication
F3 Password