Filter
Top Products
5-25
5 PROGRAM MODES
(3)Setting Parameters of RC
Set the paameters forcommunication with remote controller system.
Parameters
1) Channel
Sets communication channel
The same channel must be set for GTS-820A series and RC-2RII.
Set channels : 1, 2, 3
2) DELIMITER (Terminate)
Selecting CR (Carriage return), or LF (Line feed) will be added at the end of data.
Set items:
ETX, ETX+CR, ETX+CRLF
3) Retry
This is a method to retry setting for sending data during communication with remote controller RC-
2RII.
Set items:
Standard, Divided
Standard: Gives good for fast communication.
This is offered in normal condition.
Divided: Using in bad condition such in long distance, bad condition of sight, strong
2
Press the [F2] key to select [2PARAMETER
(CABLE)].
Speed setting screen will appear.
[F2]
3
Press the [F3](↑) or [F4](↓) key to select baud
rate then press the [F1](SET) key to decide.
[F3]
or
[F4]
[F1]
4
Set bit format in the same way.
[F3]
or
[F4]
[F1]
5
Set DELIMITER (Terminate) in the same way.
[F3]
or
[F4]
[F1]
6
Set RTS in the same way.
7
Set REC TYPE in the same way.
[F3]
or
[F4]
[F1]
l To cancel the setting, press the [F6](EXIT)key or the [ESC] key.
SPEED
9600
SET
↑
↓
EXIT
BIT FORMAT
D8 S1 NONE
SET
↑
↓
EXIT
TERMINATE
ETX
SET
↑
↓
EXIT
RTS
Hi
SET
↑
↓
EXIT
REC TYPE
REC-A
SET
↑
↓
EXIT
Setting
1 CABLE/RADIO MODEM/RC
2 PARAMETER(CABLE)
3 PARAMETER(RC)
4 PARAMETER(RADIO MODEM)