Filter
Top Products
MAINTENANCE
Side and Rear Flail Maintenance Section 4-3
©2011 Alamo Group Inc.
MAINTENANCE
Regular Maintenance
The intervals at which regular servicing should be done are based on hours of operation. Use the tractors hour
meter to determine when regular servicing is required.
Daily or Every 8 Hours
ITEM SERVICE COMMENTS
Drive Shaft Yoke, U-Joint Grease Grease as instructed in
& Stub Shaft detailed maint. section
Pump Drive Shaft Coupler Check and Lube Insure drive shaft end play
Crankshaft Adapter Check rubber grommets Replace grommets if
damaged or missing
Pivot Points Lubricate Inject grease until it
appears at ends
Hydraulic Fittings Check for leaks Tighten when needed.
Do Not use hands to
check for leaks, see
maintenance Precautions
Knives Check Inspect for missing or damaged
knives, change as needed.
Belts Check/Adjust Check if broken, tighten as required.
Main Frame and Check Retorque bolts to torque
Deck specifications in this section
Always disconnect the wire leads from the mower pump solenoid
before performing service on the Tractor or Mower. Use caution when
working on the Tractor or Mower. Tractor engine must be stopped
before working on Mower or Tractor. The Mower Blades could inadvertently be turned on
without warning and cause immediate dismemberment, injury or death.
(SBM-12a)