Filter
Top Products
Cheetah Maintenance Section 4-12
MAINTENANCE
TIGHTENING SPINDLE BOLTS
The spindle mounting bolts should be checked and retorqued daily or every 8 hours of
service as follows:
Torque the (6) bolts shown below to 357 ft. lbs. dry or 315 ft. lb. lubricated (loctite 271)
MAINTENANCE
TIGHTENING KNIFE BOLTS AND DISK BOLTS:
After every 8 hours of operation or daily, the Knife Bolts and Disk Bolts should be tightened
as follows:
Knife mounting bolts (2ea) torque to 800 ft. lbs. lubricated
Disk mounting bolts (6ea) torque to 204 ft. lbs dry or to 184 ft. lbs. lubricayed (loctite 271)