Filter
Top Products
Assembly Section 2-11
ASSEMBLY
HUSCO VALVE PLUMBING (WITH MID-MOUNT VALVE)
The tractor ports used are on the selective control valve (SCV) and the Mid-Mount
valve. The SCV is located between the right arm of the three point hitch and the axle.
The Mid-Mount valve is located under the right front corner of the cab. The power
beyond port is located on the bottom of the Mid-Mount valve towards the front. The
excessive flow port is located on the underside of the SCV. The return port is
accessed through the end of a run tee located on the SCV. See the husco lift valve
page in the parts section for hardware and location of parts. Refer to the image
below as a guide.
The power beyond port uses the existing adapter for the pressure hose. That
hose is routed to the “P” port of the husco valve. The return hose from the lift valve
is connected to the closest end on the run tee of the “T” port on the selective control
valve. Plumb the power beyond hose from the “PB” port on the husco valve to the
“EF” port on the SCV. Refer to the Parts Section for hardware used.
SCV
MID-MOUNT VALVE