Symbol Technologies T350 Brush Cutter User Manual


 
9
Assembly of the Handle
T350
WARNING!
NEVER operate this machine
without the front handle. Oper-
ating without the front handle may result
in serious injury.
NOTE:
Tighten four bolts diagonally to properly
secure the handle.
NOTE:
Adjust the handle at the best position for
operator comfort.
(1) Put four square nuts in the recess-
es on the underside of the barrier.
(2) Fit the handle and barrier over the
outer tube and tighten four bolts in a
crisscross fashion.
Throttle Cable Adjustment
(1) Pull the throttle trigger gently,
and check for free-play of
approximately 5mm.
(2) If free-play is out of specications:
(a) Slide the cable cap toward the
mufer side until the adjusting
nut and the lock nut appear.
(b) Loosen the lock nut slightly.
(c) Turn the adjusting nut so that
free-play is about 5mm.
(d) Then, tighten the lock nut.
(e) Slide the cable cap back.
(1) Loosen the two bolts of the lower
cap and remove the lower cap.
(2) Position the handle bracket
against the handle label located on
the outer tube.
(3) Attach the lower cap with the two
bolts and tighten the bolts. Make sure
the front handle is in position per the
illustration.
(4) Secure the cable to the outer pipe
with the two bands as the illustration
shows. The two bands are in the tool
bag.
BAND
HANDLEBAR
HANDLE BRACKET
HANDLE LABEL
LOWER CAP
BOLT
THROTTLE GRIP
Assembly of the Handle
C350/B450
LOCK NUT
ADJUSTING NUT
CABLE CAP
THROTTLE CABLE
OUTER TUBE
BARRIER
HANDLE
BOLT
NUT
BARRIER