Symbol Technologies T350 Brush Cutter User Manual


 
19
Does the engine
crank?
Faulty recoil starter.
Fluid in the crankcase.
Internal damage.
Consult with an authorized
servicing dealer.
Consult with an authorized
servicing dealer.
Consult with an authorized
servicing dealer.
NO
Good
compression?
Loose spark plug.
Excess wear on
cylinder, piston, rings.
Tighten and re-test.
NO
YES
Does the tank
contain fresh
fuel of the
proper grade?
Refill with clean fresh unleaded
gasoline with a pump octane of
87 or higher, mixed with
Premium 2-cycle mixing oil at a 50:1
gasoline/oil ratio.
Fuel incorrect, stale, or
contaminated; mixture
incorrect.
NO
YES
Is fuel visible
and moving in
the return line
when priming?
Check for clogged fuel
filter and/or vent.
Replace fuel filter or vent as required.
Restart.
NO
Is there spark at
the spark plug
wire terminal?
The ignition switch
is in “O” (OFF) position.
Shorted ignition ground.
Faulty ignition unit.
Move switch to “I” (ON)
position and re-start.
NO
NO
YES
YES
Check the
spark plug.
If the plug is wet, excess
fuel may be in the
cylinder.
The plug is fouled
or improperly gapped.
The plug is damaged
internally or of the
wrong size.
Crank the engine with the
plug removed, replace the
plug, and re-start.
Clean and re-gap the plug to
0.6 ~ 0.7 mm. Re-start.
Replace the plug with a
NGK BMR6A. Re-start.
YES
What To Check Possible Cause Remedy
Troubleshooting Guide
Engine Does Not Start