Symbol Technologies B450 Brush Cutter User Manual


 
12
Mixing Fuel
Filling The Fuel Tank
1. Place the unit on a flat, level surface,
and wipe any debris from around the
fuel cap.
2. Remove the fuel cap.
3. Fill the tank with clean, fresh fuel.
4. Replace the cap, and wipe away any
spilled fuel before starting the engine.
WARNING!
Minimize the risk of re,
burns, and personal injury!
 STOP engine before refueling.
 ALWAYS allow the engine to cool
before refueling
 ALWAYS open the fuel cap slowly
to allow any pressure build-up
in the tank to release fuel vapor
slowly.
 ALWAYS transport and store fuels
in an approved container.
 Avoid overlling and wipe-up all
spilled fuel. Move the engine at
least 3 meters from the fueling
point, storage area, and other
readily ammable materials before
restarting.
 ALWAYS inspect the unit for fuel
leaks before each use. During
each rell, make sure there are no
fuel leaks around the fuel cap and/
or tank. If a fuel leak is evident,
stop using the unit immediately.
Fuel leaks must be repaired before
using the unit.
 NEVER smoke or light any res
near the engine or fuel source.
 NEVER place any ammable ma-
terial near the engine or mufer.
 NEVER operate the engine without
the mufer in good working condi-
tion.
ALWAYS move the unit to a place
well away from a fuel storage area
or other readily ammable materi-
als before starting the engine.
IMPORTANT!
Mix only enough fuel for your immediate
needs! If fuel must be stored longer than
30-days, it should rst be treated with a
stabilizer such as StaBil™ or equivalent
product!
CAUTION!
Some gasolines contain alcohol as
an oxygenate! Oxygenated fuels may
cause increased operating tem-
peratures. Under certain conditions,
alcohol-based fuels may also reduce
the lubricating qualities of some mixing
oils. Never use any fuel containing
more than 10% alcohol by volume!
Generic oils and some outboard motor
oils may not be intended for use in
high-performance air cooled 2-cycle
engines, and should never be used in
your Shindaiwa engine!
CAUTION!
This engine is designed to operate on
a 50:1 mixture consisting of unleaded
gasoline and a premium 2-cycle mixing
oil only. Use of Non-approved mixing
oils can lead to excessive maintenance
costs and/or engine damage.
CAUTION!
Never attempt to mix fuel in the unit’s
fuel tank. Always mix all fuels in a
clean approved container.
Use only fresh, clean unleaded gasoline
with a pump octane rating of 87 or
higher.
Mixing fuel with a Premium 2-cycle
mixing oil designed for use with high-
performance 2-cycle air-cooled engines.
Refer to the following examples of 50:1
fuel to oil mix quantaties:
Gasoline 2-cycle mixing oil
liters milliliters
2.5 l ................................................. 50 ml
5 l ...................................................100 ml
10 l .................................................200 ml
20 l .................................................400 ml