Filter
Top Products
10
Cutting Attachment Shield Assembly
WARNING!
NEVER operate this machine
without the cutting attachment
shield. Operating without the cutting
attachment shield may result in seri-
ous injury.
(A) Cutting Attachment Shield
(1) Insert the cutting attachment
shield between the outer tube and the
lower clamp. Loosen the nut and bolt
which are tightening the lower clamp
if the cutting attachment shield does
not t with the lower clamp.
NOTE:
It may be necessary to loosen the lower
clamp bolt so that the shield will t
between the tube and clamp.
(2) Fit the two spacers (T350 only)
and the upper clamp over the outer
pipe and tighten with four bolts.
NOTE:
Tighten four bolts a crisscross fashion.
(3) Tighten the lower clamp bolt and
nut securely.
WARNING!
Carefully inspect the cutting
attachment shield assembly to
make sure it is tightened securely and
does not wobble.
(B) Shield Extension (when trimmer
head is in use)
(1) Attach the shield extension to the
cutting attachment shield.
CAUTION!
The line cutter is attached to the shield
extension and must be used when op-
erating with a trimmer head.
NOTE:
Make sure the shield extension is com-
pletely hooked at the hook receiver.
LOWER CLAMP
SPACER
SPACER
BOLT
NUT
BOLT
UPPER
CLAMP
OUTER TUBE
CUTTING
ATTACHMENT
SHIELD
CUTTING ATTACHMENT SHIELD
SHIELD EXTENTION
HOOK
HOOK
RECEIVER