Sundance Spas 780 Hot Tub User Manual


 
Page 26
and forth while pulling outward). Tip hose down and allow to drain,
then reinstall hose and clamp.
7. Re-install cabinet side panels and cover spa so that no casual moisture
can enter into it.
Consult your Authorized Sundance Dealer if you have any questions regard-
ing winter use or winterizing.
11 .9 Restarting Your Spa in Cold Weather
If you want to start up your spa after it has sat empty for a time in freezing
temperatures, be aware that the water remaining in certain sections of the
piping may still be frozen. This situation will block water flow preventing the
spa from operating properly and possibly damaging the equipment. We rec-
ommend you consult your dealer for guidance before attempting to re-start
your spa under these conditions.
12.
0 Water Quality Maintenance
Maintaining the quality of the water within specified limits will serve to
enhance your enjoyment and prolong the life of the spa's equipment. It is a
fairly simple task, but it requires regular attention because the water chem-
istry involved is a balance of several factors. There is no simple formula, and
there is no avoiding it. A careless attitude in regard to water maintenance will
result in poor and potentially unhealthful conditions for soaking and even
damage to your spa. For specific guidance on maintaining water quality, con-
sult your authorized Sundance dealer who can recommend appropriate chem-
ical products for sanitizing and maintaining your spa.
CAUTION: Never store spa chemicals inside the spa's equipment bay.
12.1 pH Control
pH is a measure of relative acidity or alkalinity of water and is measured on a
scale of 0 to 14. The midpoint of 7 is said to be neutral, above which is alka-
line and below which is acidic. In spa water, IT IS VERY IMPORTANT TO
MAINTAIN A SLIGHTLY ALKALINE CONDITION OF 7.2 to 7.8. Problems
become proportionately severe the further outside of this range the water
gets. A low pH will be corrosive to metals in the spa equipment. A high pH
will cause minerals to deposit on the interior surface (scaling). In addition, the