Filter
Top Products
temperature display flashes when this function is enabled. Example: the
“F3” skimming/heating cycle was enabled prior to choosing lock mode.
The spa continues to perform the “F3” cycle until lock mode is canceled,
allowing another cycle to be selected.
To set a time for the first skimming/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. EXAMPLE: If you desire your
first skimming/heating cycle to begin at 10:00 AM turn off power to the
spa and turn it back on again at 9:58 AM. Note: start time is approximate
and may vary slightly from day to day.
11.0 Spa Maintenance
Proper and regular maintenance of your spa will help it retain its beauty and
performance. Your authorized Sundance dealer can supply you with all the
information, supplies, and accessory products you will need to accomplish
this.
11 .1 Cleaning The Filter
Your Sundance spa is equipped with high-performance double-end filter
cartridge located inside the filter cover. Small debris is filtered by the circu-
lation pump drawing water through the short end of the filter cartridge.
Larger debris is filtered by the 2-speed pump#1 drawing water through the
larger end of the filter cartridge during normal operation and at each pro-
grammed skimming/heating cycle. Both halves work together to provides
unsurpassed water quality by trapping suspended particles on their outer
surface.
Palermo and Bahia models include filters on their footwell suction
covers that prevent debris from entering pump 2, when operating.
These filters must remain in place to protect their pump 2 plumbing network.
They should be cleaned every 2 months, or when weak pump
2 performance is observed.
To ensure optimum performance, clean and reuse the filter cartridge once a
month. ALWAYS TURN POWER TO SPA OFF BEFORE CLEANING THE
FILTER CARTRIDGES! Refer to the following filter cleaning/replacement
procedure:
Page 20