Filter
Top Products
17
Power Configurations for 680 Burlington Models (North America, 60Hz)
This section describes the power configuration choices (Standard 50 Amp and Alternate 40
AMP) for Burlington hot tub models.
Cong. #1
Standard 50A Configuration
(factory setting)
240 VAC/50A • 3-wire configuration (2
hots and a ground)
50A dual-pole GFCI breaker (hard •
wired only)
Electrical current draw of 36A •
In this Standard 50A configuration, the heater
does operate while the jets pump is running
in high-speed.
Config. #2
Alternate 40A Configuration
(For homes where 240 VAC/50A power
is unavailable).
240 VAC/40A 3-wire configuration (2 •
hots and a ground)
40A dual-pole GFCI breaker (hard •
wired only)
Electrical current draw of 26A•
If the home’s electrical system does not
have the full 240 VAC/50A, the spa may be
connected to a 240V/40A power source after
a qualified electrician makes a minor circuit
board modification.
In this configuration, the heater does not run
while the jets pump is running in high-speed.
Note
Wire size must meet NEC recommendations and is determined by
maximum current draw and length or run.
Important:
All of the alternative electrical congurations require
a qualied technician to perform minor circuit board modications. To avoid
damage to the spa, do not activate power to the spa until these modications
have been made. We recommend Square-D or Cutler Hammer circuit
breakers.