Filter
Top Products
Step 29
Measure and mark the roof box header
for the eight panels as shown in Diagram
29. The center point for marking all four
headers is 25".
Pro Tip: make any marks on the top of
the roof box header so they will not mar the
finish on the completed gazebo.
Pro Tip: To fit the rafter notch squarely
on top of the wall assembly, the rafter may
be adjusted with up to 1/4" misalignment
between the bottom of the rafter and the
bottom of the roof box header.
Step 30
Center a Mid Rafter [12] on the mark
you made on the roof header box. The
bottom of the mid rafter should be flush
with the bottom of the roof header box
and the pre-cut notch should fit squarely
on the top of the wall assembly. Attach
with one 2-1/2" screw for alignment and
safety.
Then:
Attach the mid rafter to the roof header
box with two 2-1/2" screws as shown in
Diagram 30. Repeat for the remaining
three mid rafters.
Pro Tip: Do not attach the BOTTOM
of the mid rafter to the tie plate at this
time.
14
Sundance Spas Gazebos Installation Instructions WillowWood
Variance from
1 1/2" to 2" at top
of wall assembly
Diagram 29
Diagram 30