Filter
Top Products
ENGLISHFRANÇAISEESPAÑOL
-
27
-
CLEANING AND ADJUSTING
SPARK PLUG
(a)
If the plug is contaminated with carbon,
remove it using a plug cleaner or wire
brush.
(b) Adjust the electrode gap to 0.6 to 0.7
mm (0.024 to 0.028 in.).
Gap 0.6 to 0.7 mm
(
0.024 to 0.028 in.
)
CLEANING FUEL STRAINER
Dirt and water in the fuel are removed by
the fuel strainer.
(a) Remove the strainer cup and throw
away water and dirt.
(b) Clean the screen and strainer cup with
gasoline.
(c) Tightly fasten the cup to main body,
making sure to avoid fuel leak.
HIGH ALTITUDE ENGINE OPERATION
■
Please have an authorized SUBARU Industrial Power Products service dealer modify
this engine if it is to be run continuously above 5,000 feet (1,500 meters). Failure to
do so, may result in poor engine performance, spark plug fouling, hard starting, and
increased emissions.
■
Carburetor modification by an authorized SUBARU Industrial Power Products
service dealer will improve performance and allow that this engine meets EPA
(Environmental Protection Agency) and California ARB (Air Resources Board)
emission standards throughout its useful life.
■
An engine converted for high altitudes can not be run at 5,000 feet or lower.
In doing so, the engine will overheat and cause serious engine damage.
Please have an authorized SUBARU Industrial Power Products service dealer
restore high altitude modified engines to the original factory specification before
operating below 5,000 feet.
Spark plug : BR-6HS (NGK)