Filter
Top Products
6
BASIC ASSEMBLY
To properly assemble this heater you need the supplied assembly wrench and Allen wrench (or one of your
own). Refer to the parts diagram on page 5 while assembling the heater.
PLEASE NOTE: The design of the base in the images below will slightly differ from the base provided with
the heater.
1) First, attach the base pole (D) to the weighted base (B) using the 3 base bolts (F) and 3 nuts (G). Once you
secure the base pole (D) to the weighted base (B), place the decorative cone (C) over the base pole (D) to
cover the bolts on the base.
2) Next, place the power cord attached to the heater head (A) through the middle of the base pole (D). Pull
the power cord through the bottom of the base as far as it will go.
3) Next, connect the heater head to the base pole. To do this, align the small screw holes on top of the base
pole (D) with the holes on the bottom of the heater head (A). Use the small heater head connector screws
(E) to secure the heater head (A) to the base pole (D).