Filter
Top Products
4
STEP 10: Install the grass bag adapter and secure to
the side of the deck with the two 5/16-18 nuts (P/N 9-
0951) provided in the hardware bag. See Figure 14.
FIGURE 14
STEP 11: KAWASAKI ENGINE. Attach support rod to
deck adapter by first removing the nut and bolt at the
rope guide pulley. Reassemble with the support rod
underneath the pulley and the flattened end of the rod
towards the engine. Attach the support rod to the top of
the engine. Remove the nut and washer from the right
rear corner of the recoil housing as shown. Place the
support rod over the threaded engine stud. Install nut
only (washer not needed) and re-tighten the nut. See
Figure 15.
STEP 11: ROBIN 4-CYCLE ENGINE. The installation
of the support rod on the Robin 4-cycle engine is
saimilar to the installation on the Kawasaki engine
described above. On the Robin installation, the rope
guide end of the support rod is on top of the pulley and
the flattened end is attached to the engine with a 6 MM
hex bolt and flat washer (included in the hardware bag
with the mower). A support rod is not required on
mowers equiped with Robin 2-cycle engines. See
Figure 16.
FIGURE 15
FIGURE 16
SECURE ADATER TO
DECK WITH NUTS
SUPPORT ROD
ROPE GUIDE
NUT
6 MM HEX BOLT
AND FLAT
WASHER
SUPPORT ROD
ON TOP OF ROPE
GUIDE PULLEY