Filter
Top Products
2
STEP 5: Install speed control rod by tilting the lever
down in a horizontal position and insert into the anchor
from the side as shown in Figure 5.
FIGURE 5
STEP 6: Rotate control rod up to be connected to the
speed sector. Slide flat washer and spring in front of
speed sector. See Figure 6. Compress spring by pulling
backwards and pulling control lever into the notch. Pull
backwards far enough to clear the sector flanges. This
will lock speed control lever handle into position. Control
rod should move back and forth freely between sector
flanges. See Figure 7.
FIGURE 6
FIGURE 7
STEP 7: Insert the transfer rod into the hole in the end
of the control rod and clip as shown in Figure 8. Hold
transfer rod in place rotate clip over until it snaps into
position onto transfer rod. See Figure 9.
FIGURE 8
FIGURE 9
ANCHOR
ROTATE UPWARD TO
SPEED SECTOR
SPEED
CONTROL
ROD
SECTOR
FLANGES
SPEED
SECTOR
FLAT
WASHER
NOTCH
SPRING
PUSH UP INTO NOTCH AND PULL
TOWARD OPERATOR UNTIL HANDLE
CLEARS SECTOR FLANGES
SECTOR FLANGES
MOVE BACK AND
FORTH BETWEEN
FLANGES
1. PLACE END OF
CLIP OVER END OF
CONTROL ROD.
3. PRESS END OF
CLIP DOWN ONTO
TRANSFER ROD.
TRANSFER
ROD
2. INSERT END OF
TRANSFER ROD
THRU HOLE IN CLIP
AND CONTROL ROD.
HOLE IN
CONTROL
ROD
SNAP CLIP ONTO
TRANSFER
RETAINING
CLIP
TRANSFER
ROD