Filter
Top Products
22
SECTION 4 - SERVICE & LUBRICATION
HOURS PROCEDURE COMMENTS
BREAK-IN Check all fasteners for proper tightness
Change Engine Oil and Filter at 5 hours .............................. See engine manual
Change Hydraulic Oil and Filter at 25 hours ........................ Use SAE 10W-30
8 HOURS Check/Change Engine Oil ................................................... Change oil if extreme dusty conditions
(Daily) Clean Air Filter...................................................................... More often if needed
Clean Blower screen ............................................................ More often if needed
Remove Debris from under Belt Cover ................................ More often if needed
Sharpen Cutter Blades......................................................... Tighten Cap Screw to 70 - 80 ft. lbs.
Grease Cutter Spindle Bearings........................................... Use Chevron SRI Grease or equal
Check Hydraulic Reservoir................................................... Add oil if needed
40 HOURS Check Tire Pressure ............................................................ Add or adjust as Required
(Weekly) Check Safety Interlock System ............................................ Inspect Switches for ease of Operation
Lube Traction (Drive) Levers................................................ Oil - Medium Duty
Inspect Traction Lock for Wear............................................ Replace if Worn
Lubricate Switch Balls at Pumps.......................................... General Purpose Grease
Change Engine Oil ............................................................... More often if needed
Replace Air Filter.................................................................. More often if needed
Grease Caster Wheel Bearings ........................................... General Purpose Grease
Grease Caster Wheel Pivot.................................................. General Purpose Grease
Grease Idler Arm Pivots....................................................... General Purpose Grease
200 HOURS Fuel Filter ............................................................................. Replace with Snapper P/N 1-4359
(Monthly) Check all Fasteners for Proper tightness............................. See Torque Specifications
Change Engine Oil Filter ...................................................... See Engine Manual
Clean and Adjust Spark Plugs ............................................. See Engine Manual
Check Belt Tension
Lube Controls and Linkages ................................................ Use Medium Duty Oil
Change Hydraulic Oil and Filter ........................................... Use SAE 10W-30 Oil
GREASE ZERK LOCATION
GREASE
DAILY
GREASE
WEEKLY
1 on the Hydro Pump Belt Idler Arm Pivot
X
1 on each Spindle Housing (Total of 2 on 36” Deck & 3 on 48”, 52”, 48”, & 61” Decks)
X
1 on each Idler Arm Pivot (Total of 1 on 36” Deck & 2 on 48”, 52”, 48”, & 61” Decks)
X
1 on each Caster Support Arm (Total of 2)
X
1 on each Caster Wheel (Total of 2)
X
MAINTENANCE/REPLACEMENT PARTS
MAINTENANCE PARTS
36” Cutter Blade (Requires Two Blades) 2-9246
48” Cutter Blade (Requires Three Blades) 2-9247
52” Cutter Blade (Requires Three Blades) 2-9246
61” Cutter Blade (Requires Three Blades) 2-9251
36” Deck Engine to Cutting Deck Belt 2-9255
48” Deck Engine to Cutting Deck Belt 2-9262
48” Deck Spindle to Spindle Belt 2-9261
52” Deck Engine to Cutting Deck Belt 2-9267
52” Deck Spindle to Spindle Belt 2-9266
61” Deck Engine to Cutting Deck Belt 2-9269
61” Deck Spindle to Spindle Belt 2-9268
Parts Manual for Pro Hydro Series 0 06926