Filter
Top Products
2
FIGURE 3
3. Installing Tie Rods
A. Install bushings onto tie rods.
B. Install tie rods into steering shaft. Secure with 3/8”
flat washers and 5/32” x 1” cotter-pins. See Figure
1 and Figure 4.
FIGURE 4
LUBRICATION
1. Differential
A. Perform normal lubrication of the Rear Engine
Rider. Check differential for proper lubricant
levels. See Operator’s Manual.
2. Chain Case
A. Perform normal lubrication of the Rear Engine
Rider. Check chain case for proper lubricant
levels. See Operator’s Manual.
B. After completing lubrication, carefully lower
Rear Engine Rider to floor to continue set-up.
FUEL SYSTEM
1. Fuel Tank
A. Place fuel tank in bracket behind seat bracket
and push tank down until it snaps into
position. See Figure 5.
2. Fuel Line
A. Slide fuel line onto fuel tank hose barb and
move hose clamp above end of the fuel tank
hose barb (approximately 1/8” from end of
hose). The fuel filter has been installed by the
engine manufacturer. See Figure 6.
FIGURE 5
FIGURE 6
SUPPORT STEERING
WHEEL WHILE
DRIVING ROLL PIN
STEERING
WHEEL WITH
OFFSET
TOWARDS
OPERATOR’S
SEAT
1/4” X 1-1/2”
ROLL PIN
STEERING ARM
5/32” X 1”
COTTER PIN
3/8” FLAT
WASHER
BUSHIN
G
TIE ROD
FUEL TANK ORIENTATION
PUSH DOWN
HOSE
CLAMP
FUEL
TANK
FUEL
LINE
FUEL
FILTER