Filter
Top Products
17
Section 4 - MAINTENANCE
4.3.3. RIDING MOWER - LUBRICATION
1. Front Wheel Bearings
Lubricate with Kendall NLGI No. 2 lithium grease or
equivalent, from a grease gun. See Figure 4.5.
FIGURE 4.5
2. Hydro Pumps
Check the level of the fluid in both of the fluid reservoirs.
Wipe away all dirt and debris from around reservoir cap
before removing. Oil must remain absolutely clean!
Check with machine on a level surface with engine
“OFF”. Fill reservoir as needed to bring level up. The
reservoir is properly filled when the fluid level is 1½”
below the top of the filler neck. DO NOT OVER FILL.
Use clean, fresh premium automotive oil having a
viscosity equivalent to SAE 20W50 API SL. The fluid
should be chemically stable, incorporating rust and
oxidation inhibitors. Make sure funnels, pouring spouts
and oil can are completely clean. Reinstall reservoir cap.
See Figure 4.6.
3. Other Lubrication Points
Lubricate machine caster wheel shafts, traction idler arm
and mower deck idler arms with Kendall NLGI No. 2
lithium grease or equivalent, from a grease gun. See
Figure 4.7.
4.4 BEFORE OPERATING MACHINE
1. Clean all dirt and debris from around the two hydraulic
fluid reservoirs. Especially around the top and cap area.
2. Clean all dirt and debris from the cooling fins on the
engine and from both hydraulic pumps.
4.5 ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in Section “AFTER
EVERY 25 OPERATING HOURS”. Refer to Section
“Service Schedule”.
4.5.1. ENGINE
Service engine according to engine owner’s manual.
FIGURE 4.6
FIGURE 4.7
(Continued on next Page)
LUBRICATE
BEARINGS
FRONT
WHEEL
LUBRICATE MOWER
DECK IDLER ARMS
HYDRAULIC FLUID RESERVOIRS
LUBRICATE TRACTION
DRIVE IDLER ARM
ELECTRIC
CLUTCH