Snapper LT23460, LT195420, LT24520, SLT23460, SLT24520, CLT23460, CLT24520 Lawn Mower User Manual


 
How to Replace the Light Bulb
1. Raise the tractor hood.
2. Turn the light socket until the tabs on the socket align
with the notches in the bezel (Figure 46). Remove the
light socket. Turn the light bulb and remove the bulb.
3. Install a new light bulb. Align the light socket with the
notches in the bezel and turn the light socket to lock in
position.
Figure 47: Light bulb replacement
A - Bezel
B - Light bulb
C - Light socket
How to Clean the Mower Deck
WARNING: Before you clean the mower deck, stop
the engine and disconnect the wire to the spark
plug.
Grass and other debris on top of the mower deck can keep
the belt from working correctly. For safety and correct
operation, frequently clean the top of the mower deck.
Remove grass and debris from around the pulleys and other
moving parts.
1. Move the lever for the blade rotation control to the
ENGAGE position (42” models only).
2. Clean the top of the mower deck.
3. Move the lever for the blade rotation control to the
DISENGAGE position (42” models only).
4. Again clean the top of the mower deck (42” models
only).
5. After you cut the grass, clean the bottom of the mower
deck.
Storage (over 30 days)
At the end of each year, prepare the unit for storage as
follows.
The Engine
For storage information, see the the engine manufacturer’s
instructions.
The Battery
1. Remove the battery.
2. Clean the battery terminals of any deposits.
3. Charge the battery. See the instructions on “How To
Prepare And Charge The Battery”.
4. Store the battery in a cool, dry place.
NOTE: After a long time in storage, charge the battery.
The Fuel System
WARNING: Do not drain the gasoline inside a
building or near a fire. Do not smoke because the
fumes from the fuel can cause an explosion.
1. Start the engine.
2. Run the engine until the fuel tank and the carburetor
are out of fuel and the engine stops.
3. After storage, make sure you use fresh fuel.
Clean the Unit
1. Clean the dirt and grass from the engine.
2. Clean the mower housing.
Lubricate the Unit
See the “Lubrication” instructions in this book.
39
English
C
A
B