Filter
Top Products
How to Install the Wheels
If the wheels must be removed for service, make sure they
are installed as follows.
Front Wheel:
1. Make sure the valve stem is to the outside of the
tractor. Slide the front wheel on the spindle (See
Figure 44).
2. Fasten the front wheel with washer and cotter pin.
Bend the ends of the cotter pin apart to keep the front
wheel on the spindle.
3. If your model has hub caps, install the hub caps. Make
sure the washers hold the hub caps in place.
Figure 44: Front wheel assembly
A - Cotter pin
B - Hub cap
C - Valve stem
D - Front wheel
E - Spindle
F - Washers
Rear Wheel:
1. Install the washers and spacer onto the axle as shown
in Figure 45.
2. Mount the square key in the key slot (See Figure 45).
3. Make sure the valve stem is to the outside of the
tractor. Align the slot in the rear wheel with the square
key. Slide the rear wheel on the axle.
4. Fasten the rear wheel with washer and e-ring.
5. If your model has hub caps, install the hub caps. Make
sure the washers hold the hub caps in place.
Figure 45: Rear wheel assembly
A - Rear wheel
B - Hub cap
C - E-ring
D - Washer
E - Valve stem
F - Spacer
G - Washer
H - Square key
I - Key slot
J - Axle
How to Replace the Fuse
If the fuse is blown, the engine will not start. The location of
the fuse is behind the panel between the engine and the
control console. Remove the fuse and replace with an
automotive fuse of equivalent rating (Figure 46).
Figure 46: Fuse location
A - Automotive fuse
38 www.snapper.com
English
A
B
C
D
E
F
A
A
H
I
G
B
D
C
E
F
J