Filter
Top Products
11
Troubleshooting, Adjustments, & Service
Figure 3. Adjusting Skid Shoes
Skid Shoe Adjustment
On smooth surfaces such as concrete or asphalt, the
scraper bar should scrape the surface. On surfaces such
as gravel, the scraper bar should be set high enough so
that it will not pick up debris.
1. Loosen the nuts securing the skid shoes (see
Figure 3).
2. Raise or lower the scraper bar to the desired height.
Use wood blocks to hold the snow thrower in posi-
tion.
3. Set the skid shoes so that they are in contact with the
ground and tighten the skid shoe nuts.
Electric Chute Rotator Gear
1. Remove the cover and loosen the three screws (B,
Figure 4) securing the electric chute rotator motor.
2. Adjust the motor (C) so that the gear (A) meshes with
the discharge chute ring gear and tighten the adjust-
ment screws (B).
3. Reinstall the cover.
Loosen Nuts
to Adjust
Figure 4. Chute Rotator Gear
A
B
C