Filter
Top Products
8
CART ASSEMBLY
1. Determine if you have a right side or left side dis-
charge. Refer to Figures 4 & 5.
2. Install the wheel assemblies (A, Figure 6) to the
frame (B). Place the head of the swivel wheel on the
end of the frame. Align the holes and place four 3/8-
16 x 1 hex bolts up through the frame and head of
the swivel. Secure with four flat washers (13/32 I.D.,
7/8 O.D.) and 3/8-16 locknuts.
3. Install the U-bracket (A, Figure 7) to the bottom of the
box (B). Place the three 5/16-18 x 3/4 slotted truss
head bolts and three flat washers (11/32 I.D., 3/4
O.D.) through the inside of the box and the U-brack-
et. Secure with three 5/16 lockwashers and nuts.
4. Turn box upside down and install the frame to the U
bracket (Figure 8). Align the two prong end (A) in the
frame with the ends of the U-bracket and secure with
two 1/2-13 x 1-1/4 hex bolts and locknuts. DO NOT
over-tighten the locknuts, since the box pivots at this
point for dumping.
5. Turn box with frame upright and install the latch han-
dle (A, Figure 9) and two lift handles (B) as follows:
A. Refer to Figure 3. Latch Handle: Place one 5/16-
18 x 1 hex bolt with 5/16 spring washer through the
inside of the box. Next place a 5/16 flat washer over
the bolt on the outside of the box, the latch handle, a
5/16 flat washer, a 5/16 spring washer and a 5/16 nut
and jam nut. Tighten the nuts so that when the latch
handle turns the bolt and nut will not turn. (Be sure
the cups of the spring washers are facing toward the
box surface on both sides.)
B. Refer to Figure 3. Lift Handles: Install the two lift
handles on the outside of the box. Place two 1/4-20 x
1/2 slotted truss head bolts through the inside of the
box and the lift handle. Secure with two 1/4 lock-
washers and nuts.
Figure 7. Install U-Bracket
A. U-Bracket B. Box
A
B
Figure 8. Install Frame (RH Dishcarge Shown)
A. Prong End
Figure 9. Install Latch Handle
(RH Dishcarge Shown)
A. Latch Handle B. Lift Handle
Figure 6. Wheel Assembly (RH Dishcarge Shown)
A. Wheel Assembly B. Frame
Initial Assembly &
Installation
B
A
D
B
A
A