Filter
Top Products
Section 3 - MAINTENANCE
3.4 ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in the maintenance
schedule.
3.4.1. Engine
Refer to engine owner's manual for service
instructions.
3.4.2. Spark Plug
Refer to engine owner's manual for service
instructions.
3.5 STORAGE PROCEDURE
Refer to the Engine Owner's Manual for directions
regarding engine storage preparations. Prepare the snow
thrower for "end of season" storage as follows:
1. Drain fuel from fuel tank and let engine run until
all fuel is out of the carburetor.
2. Disconnect and remove the spark plug wire
away from spark plug before any other
preparations are made!
3. Tape all openings closed to prevent spraying
water into exhaust or air intakes during washing.
4. Tilt snow thrower up on its wheels and
thoroughly clean the underside of the auger.
5. Lubricate all exposed metal with a light coating
of oil to prevent corrosion.
6. Store the machine in a shed or other dry area,
protected from weather.
3.6 MAINTENANCE and SERVICE PARTS
MAINTENANCE and SERVICE PARTS
Auger Drive Belt (Tecumseh Engines) 1-5152
Wheel Drive Belt (4 HP & 5 HP Engines) 1-5151
Wheel Drive Belt (5.5 HP Engines) 4-5214
Wheel Drive Belt (6 HP & 7 HP Engines) 2-3416
Scraper Blade (22" Width Auger) 3-3298
Scraper Blade (24" Width Auger) 3-6163
Rubber Drive Tire 2-3364
Shear Bolts - 1/4-20 x 1-1/2" 1-5257
Hex Nuts - 1/4-20 7-6978
Parts Manual for Intermediate Frame Snow Thrower - Series 3 #06045
Domestic Models: 14223, 15223, 155223, 16223, 17243,
European Models: EI5223,EI55223, EI7243
11