Filter
Top Products
42” Snow Plow/Dozer Blade
8. Assemble the chain (A, figure 4) to the tractor as
follows:
a. On left-hand side, remove the upper self-tapping
screw that holds bumper to frame. This is the hole
used for installing chain in the following steps,
using one 5/16-18x
l-114 capscrew (B), two 5/16
washers (D), and one
5/16 locknut.
b. Place one 5/16 washer onto the screw. Then place
the chain on the capscrew, and then the other
5/16 washer.
c.
Insert the capscrew (B, figure 4) as shown. From
inside frame, install
5/16
locknut onto capscrew.
Tighten snug only at this time. The spring (C) will
be installed in “Installation” section (step 6), and
hardware will be tightened.
I
Figure 4. Chain
A. Chain
B.
Capscrew
C. Spring
D. Flat Washer
INSTALLATION
1. Drive the tractor over the push bar until rear of
push bar is under front hitch.
P.Stop engine, remove key and set parking brake.
3.Attach the bracket (J, figure 5) to the two rear
holes in the tractor
hitch
with the four pins
(F)
and
safety clips (G) provided. Insert the pins from the
outside. Make sure the push bar mounting holes
(in the bracket) are toward the front.
4.Attach the push bar to the bracket, using the two
3/8-16x
2-l/4
capscrew (H) and 3/8 locknuts
(I)
provided.
gure 5. Hitch and Lift Rod
Lift Rod
G. Safety Clip
Front Set Collar
H. Capscrew.
3/8-16x
Spring Clip
2-;I4
Spring
I. Locknut,
3/S-16
Rear Set Collar
J. Bracket
Pin
K. Push Bar