Filter
Top Products
Initial Hitch & Tube Installation
8
A
Figure 11. Install Cover to Channel Assembly
A. Cover
B. Pin
C. Hair Pin
D. Channel Assembly
C
C
B
Figure 10. Install Tubes and End Caps
A. Cross Bar
B. Tubes
C. Capscrews, 5/16-18 x 2
D. Locknuts, Center Lock, 5/16-18
E. Square End Plugs
F. Round End Plugs
E
D
F
B
F
C
F
B
F
C
F
C
F
D
D
E
D
A
INSTALL TUBES AND END PLUGS
1. Install the tubes (B, Figure 10) to cross bar (A) secur-
ing with 5/16-18 x 2 capscrews (C) and 5/16-18 lock-
nuts (D).
2. Install square end plugs (E) to cross bar (A) as
shown.
3. Install round end plugs (F) to tubes (B) as shown.
INSTALL COVER TO CHANNEL ASSEMBLY
1. Set cover (A, Figure 11) on channel assembly. Slide
pin (B) through hinge on cover and channel assembly
(D) securing with hair pin (C).
INSTALL CLIP TO BAG ASSEMBLY
1. Slide the white bar (A, Figure 12) onto bag assembly
(B) as shown.
B
D
A
Figure 12. Install Clip to Bag
A. White Bar
B. Bag Assembly
Figure 13. Install Collector Bags
A. Cover
B. Collector Bags
C. Tubes
A
C
B
Bag and Tube Installation
INSTALL COLLECTOR BAGS
1. Raise the cover (A, Figure 13).
2. Slide collector bags (B) onto tubes (C) with the white
bar towards the rear.
Note: It may be necessary to fold seat forward to allow
cover to stay in the raised position.