Filter
Top Products
8
Initial Setup & Assembly
30” MODELS -
BLADE AND ADAPTER ASSEMBLY
Blade Assembly - 30” Mower
1. Remove the mower deck to access the blade or
using an overhead hoist, elevate the front of the unit
to access the mower blade.
2. Mount the lifts (B, Figure 6) to the discharge side of
the blade as shown. Torque nuts to 14 ft. lbs.
Adapter & Mounting Hardware Installation -
30” Mower
1. Install reinforcement strap (A, figure 7) inside the
adapter and secure it to the top outer holes using two
10-24 x 5/8" flat head screws (B), flat washers (C)
and 10-24 nuts (D). Be sure the cut-off bracket (G) is
installed between the reinforcement plate (A) and
adapter.
2. In rear hole of mower deck, install 5/16-18 x 1-1/4
carriage bolt (E) from the bottom and secure with
5/16" jam nut (F).
Figure 7.
A. Reinforcement Plate
B. Flathead Screw, 10-1/4 x 5*8
C. Flat Washer
D. Nut
E. Carriage Bolt, 5/16-18 x 1-1/4
F. Jam But, 5/16-18
G. Cut-Off Bracket
D
C
D
C
A
B
A
F
E