Filter
Top Products
6
Normal Installation & Removal
3. Open grass bag cover and install grass bag frames
(A, figure 3) to support brackets (B).
4. On 30" mower, lift the deflector (C) up and install the
adapter (A, figure 4) to mower deck by hooking
bracket over the rear carriage bolt and securing with
jam nut (D) and positioning front slot on the adapter
under wing nut (B). Secure by tightening knob and
wing nut. Make sure that bottom of adapter is below
stone guard.
On 34" mower, lift up deflector (C) and install the
adapter by hooking rear bracket over the mower
hinge rod and positioning front slot on the adapter
under wing nut (B). Tighten wing nut. Make sure that
bottom of adapter is below stone guard.
5. Apply dry talc to rubber seal at cover opening. Install
tube (A, figure 5) as far as possible into opening to
clear adapter and install over adapter. Secure by
rotating wire form (B) down into locked position over
puck on adapter.
6. To remove the grass catcher assembly, reverse
steps 1 - 5. Make sure deflector (C, Figure 4) is in
proper operating position after removal of grass
catcher adapter.
Figure 4. (30” Mower Shown)
A. Adapter
B. Wing Nut
C. Deflector
D. Jam nut, 5/16-18
E. 1/2” Hole
Figure 3.
A. Grass Bag Frame
B. Support Bracket