Shindaiwa HT254EF Trimmer User Manual


 
11
Maintenance and Adjustments
IMPORTANT!
Maintenance, replacement or repair of emission control devices and systems may be performed by any repair establishment
or individual; however, warranty repairs must be performed by a dealer or service center authorized by Echo, Inc The use of
parts that are not equivalent in performance and durability to authorized parts may impair the effectiveness of the emission
control system and may have a bearing on the outcome of a warranty claim.
WARNING!
Accidental start-ups can cause
severe injury! Before performing any
maintenance on this equipment, stop
the engine and disconnect the spark
plug!
Clean de-
bris from
tank and
mufer
Inspect
cooling ns,
and clean as
required
Clean around
spark plug
Inspect/clean
air lter
element
Check cutters and
guide bar for damage
and that bolts
are tight
Lubricate
cutters
Daily Maintenance/Inspection
Figure 12
Inspect handles for damaged or
loose attachments
Remove all grass clippings and dirt from the hedge trimmer.1.
Remove any compacted debris from around the fuel tank and/or mufer.
Inspect the engine cooling ns for clogging, and clean as necessary.
Clean under the cylinder cover and around the spark plug.
Inspect the air lter element for clogging, clean as necessary.
Check for loose, damaged, or missing components, and repair as necessary.2.
Lubricate the cutters with oil before use, and after refueling.3.
Check the cutters for damage and make sure all bolts are tight.4.
WARNING!
To reduce re hazard, keep the engine and mufer free of debris, leaves, or
excessive grease.
Keep cooling air
intake passages
clean
(Fuel tank
removed for
clarity)
Figure 13
Keep cooling
ns clean
Air Filter
The H4 engine that powers your Shindaiwa model is a hybrid 4-stroke engine. As a hybrid, the engine is lubricated by oil mixed
with the gasoline and air from the carburetor that moves through and around the internal parts of the engine in a similar way that
a 2-stroke engine is lubricated. Without the heavy duty 2-stage air lter equipped on all H4 engines, dust and dirt could also move
through the engine, decreasing engine life, increasing valve wear and the need for more frequent valve adjustments. To keep
your H4 engine strong and reliable, Shindaiwa recommends that you check and service the air lter as instructed in the 10-Hour
Maintenance section that follows.
NOTE:
Using non-standard replacement parts
could invalidate your Shindaiwa warranty.