Filter
Top Products
9
Turn the C2510 upside down so the gear
case output shaft is facing UP and remove
the shaft bolt, bolt guard and holder B from
the gear case shaft.
1. Align the hole in blade holder A with
the matching hole in the gear case
flange and then temporarily lock the
output shaft by inserting a hex wrench
through both holes. See Figure 12.
2. Slide the safety clip off-center. See
Figure 13.
3. Fit the blade over the safety clip and
then center it over the flange on holder
A. See Figure 14.
Installing a Blade
NOTE:
When installing certain blades, it may be
necessary
to temporarily remove the safety clip
.
CAUTION!
Install the blade so its printed surface
is visible to the operator when the
brushcutter is in the normal operating
position.
WARNING!
The blade must t at against the
holder ange. The blade mounting hole
must be centered over the raised boss
on blade holder A.
WARNING!
Never operate the C2510 without the
safety clip in place!
4. Lock the blade in place by centering
the safety clip on the output shaft.
See Figure 14.
IMPORTANT!
The machined recess in holder B must
completely surround the safety clip, and
both holders must be at against the sur-
face of the blade.
5. Install blade holder B on the output
shaft. See Figure 15. The recess in the
holder must completely cover the safety
clip, and must fit tightly against the
blade.
6.
Install the bolt guard and then the blade
retaining bolt. Using the combination spark
plug wrench/screwdriver, tighten the bolt
firmly in a counter-clockwise direction.
7. Remove the hex wrench.
Slide the safety clip off-center
Slip the Saw Blade
In Place
Slide the Safety Clip
Back
Shaft Bolt
Bolt Guard
Holder B
Output Shaft
Holder A
Hex
Wrench
Figure 12
Blade
Hex Wrench
Blade Holder B
Tighten the assembly (blade not
shown for clarity)
Figure 15
Safety Clip
Safety
Clip
Output
Shaft
Figure 13
Figure 14
Output
Shaft
The C2510 should now be com-
pletely assembled and
ready for use with a blade.