Filter
Top Products
ASSEMBLY
2412 01/11 Assembly Section 3-5
© 2011 Alamo Group Inc.
ASSEMBLY
Assembly
Installing Mounting Brackets
Install all mounting brackets on the tractor according to instructions packed with mounting kit.
Installing Loader
Install loader onto mounting brackets on tractor according to instructions packed with mounting kit.
Installing Grease Fittings
Install 1/4 straight grease fittings (11) into the road end of bucket cylinders.
Note: Grease fittings should point upward when rod ends are attached to bucket.
Installing Bucket
Attach bucket to the lift boom frame and bucket cylinders with 1-1/4 x 8 pins (29), 1-1/2 x 8-5/8 pins (6) and
hardware (24 and 26).
Installing Bucket Level Indicator
Attach indicator guide tube (13) to the bucket cylinder base pin on the right side of lift boom frame.
Slide bucket level indicator rod (23) into the guide tube and attach the other end of rod to the bucket cylinder
rod pin.
Locate tractor and loader on level surface. With the bottom of bucket resting on surface, cut off the excess rod
(23) flush with the end of guide tube (13).