Filter
Top Products
ASSEMBLY
2407TL 01/11 Assembly Section 3-5
© 2011 Alamo Group Inc.
ASSEMBLY
6. Remove linch pins and 1” hitch pins from loader upright.
7. Start tractor engine and release brakes. Retract bucket cylinders to allow parking stands to contact ground.
8. Extend lift cylinders 6” to 8” to rotate top of
loader uprights forward out of the mount,
allowing tractor to be pushed rearward. Retract
bucket cylinders until lower loader upright pins
clear mount pin saddles and front tires (See
Figure Asm-L-0026).
9. Move tractor rearward approximately 6”, being
certain not to stretch hydraulic hoses.
10. Stop tractor engine and set parking brake.
Relax lift cylinders and bucket cylinders by
moving each control lever in both directions.
Disconnect hydraulic hoses from tractor.
11. Start tractor engine and release brakes. Slowly
back tractor out of loader.