Filter
Top Products
OPERATION
1900 07/10 Operation Section 4-34
© 2010 Alamo Group Inc.
OPERATION
16.6 Operating the Attached Mower Heads
Refer to the Assembly Section of this manual to ensure the head is properly attached to the boom hitch and
hydraulic lines are properly connected.
Flail
• The H48 is rated to cut material up to 1” in
diameter. The F48 is rated for 1-1/2” diameter
material.
• Setting cutting height ranges from 3/4” to 6”.
Cutting height is set by adjusting the height of
the roller assembly.
When operating near the ground or when mulching
be particularly careful that there are no bystanders
or animals within a 300 feet. Debri tends to fly out at
great speed and can injure or even cause death.
There are obvious and hidden potential hazards in the operation of this
Mower. REMEMBER! This machine is often operated in heavy brush
and in heavy weeds. The Blades of this Mower can throw objects if
shields are not properly installed and maintained. Serious injury or even
death may occur unless care is taken to insure the safety of the operator,
bystanders, or passersby in the area. Do not operate this machine with
anyone in the immediate area. Stop mowing if anyone is within 300 feet
of mower.
(SGM-02)
Sickle Bar
• The Sickle Bar Cutter will cut a 5’ swath
through tough weeds and grass.
• The Sickle Bar Cutter is operated attached to
the boom arm and is ideal for vegetation
maintenance
• When operating the Sickle Bar correctly it will
give you a fast, efficient, and cost-effective
method of vegetation maintenance.
• The Sickle Bar will also cut vegetation through
tough weeds under water, ideal for maintaining
ponds, creeks, and other areas that may be
under shallow water.
• When operating the unit be sure there are no
bystanders or animals within 300 feet of the
unit
. OPS-B- 0049