Filter
Top Products
11
MOUNTING THE 2
ND
WHEEL
(UPON REQUEST)
To mount the 2
nd
wheel kit, follow the below steps:
a. Insert there spacer (3) into the wheel hexagon (1)
and fix it by the safety pin (4).
b. Install the second wheel (2) and fix it by its screw
(6) and washer (5).
− This procedure has to be done on both wheels.
MAINTENANCE
To ensure continuing reliability, use only original
spare parts when overhauling or repairing your mo-
tor-mower.
ENGINE
Make sure you do comply with the safety precautions
contained in the engine Operation and Maintenance
Manual.
During the first 50 hours (running in)
For the first 50 hours do not use the machine for
heavy duty work. The following additional instructions
must also be complied with during the running in pe-
riod.
DRY AIR FILTER
Every 8 hours
Clean carefully the cartridge and if is necessary re-
place it.
GEARBOX AND TRANSMISSION
After the first 50 hours (running in)
Change the gear/transmission oil (see figure 13).
Change the oil when the engine is hot to facilitate
draining of oil.
a. Remove the left wheel.
b. Remove the oil dip-stick (1).
c. Remove the oil drain plug (2) from the bottom of
the gearbox (right side) and let the exhausted oil
drain out. When fully drained, reinstall the plug (2).
d. Fill up with new oil (1.2 litres) of the following
types:
− SAE 90 for ambient temperatures between
-6 and +32°C;
− SAE 140 for ambient temperatures between
+32 and +60°C.
Every 20 hours
Check the level of the oil in the gearbox. The level
must reach between the maximum and minimum
notch on the dip-stick (1).
NOTE
Check the oil level with the motor cold and with the
motor-mower on level ground.