Filter
Top Products
11
A
A
B
B
D
C
E
B
A
A
SPA SHELL DIAGRAM
SPA OPERATION
Refer to the diagram above. The function of each
component is explained below:
The six uni-directional thera-jets (A) are located on
the sides of the spa. Five jets focus a water massage
on your upper or lower back. The remaining jet pro-
vides a foot hydro-massage when you are in the
reclining seat.
The three multi-directional thera-jets (B) can be
adjusted for a custom hydro-massage. One of the jets
is located on the reclining seat and focuses the water
massage on your lower back. Another jet is located
on one of the bench seats, below a uni-directional
thera-jet, and focuses a water massage on your lower
or middle back. The remaining jet, located on the
other bench seat, focuses a water massage on your
upper or lower back.
Note: Each thera-jet can be shut off by being pressed
in and turned back on by being pulled out.
The filter (C) can be removed for cleaning and
replacement (see page 17).
The suction vent (D), located near the floor of the
spa, brings the water into the pump, in order to oper-
ate the system. The suction cover should always be in
place over the suction vent. Never operate the spa
without the suction cover in place.
This spa is ozone ready. An optional ozone generator
can be installed to utilize the ozone jet (E). Ozone
provides a way to help sanitize your spa with minimal
chemical treatment.
The temperature probe (F) reads the current water
temperature, which is displayed on the console.
The spa also has a light (G) for evening use.
The spa features automatic freeze protection. If the
water temperature falls below 40°F (4°C), the pump
will begin circulating and heating the water to prevent
the water from freezing.
F
G