Filter
Top Products
i¸,¸1
SERVICE AND ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
• Depress clutch/brake pedal fully and set parking brake.
• Place gearshift lever in neutral (N) position.
o Place attachment clutch in "DISENGAGED" position.
• Turn ignition key "OFF" and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where itcannot come in contact with
plug.
ii = _ I I =
TO REMOVE MOWER (See Fig. 18)
Mower wil_beeasier to remove from the right side of tractor_
• Place attachment clutch in "DISENGAGED" position_
° Move attachment lift lever forward to lower mower to its CLUTCH
lowest position, SUSPENSION
• Roll belt off engine pulley.
° Disconnect clutch rod from clutch lever by removing
retainer spring.
• Disconnect anti-sway, bar from chassis bracket by
removing retainer spnng,
° Disconnect suspension arms from rear deck brackets
by removing retainer springs.
• Disconnect front links from deck by removing retainer
springs.
• Raise lift lever to raise suspension arms, Slide mower
out from under tractor, RETAINER
IMPORTANT; IF AN ATTACHMENT OTHER THAN THE SPRING
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS.
TO INSTALL MOWER (See Fig. 18)
• Raise attachment lift lever to its highest position.
o Slide mower under tractor with discharge guard to right
side of tractor_
° Lower lift lever to its lowest position_
° Install mower in reverse order of removal instructions.
SPRING
ENGINE
PULLEY
FRONT
LINK
SPR|NGS
SIDES)
ANTI-SWAY BAR
RETAINER
SPRINGS
(BOTH SIDES)
FIG. 18
21