Filter
Top Products
TO START ENGINE W_TH A WEAK BAKERY TO REPLACE HEADLIGHT BULB
(See Fig, 29) • Raise hood.
o Putt bulb holder out of the tote n the backside of the
If your batteR' is too weak to stad the engine, t should be
if 'jumper cables' are used for emergency
starling, follow this procedure:
IMPORTANT: YOUR TRACTOR }S EQUPPEDWTH A !2
VOLT NEGATIVE GROUNDED SYSTEM THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTL:M_ DO NOT USE YOUR TRAC'TOR
BATTERY TO START OTHER VEH_CL.ES
TO ATTACH JUMPER CABLES
Connect each end of the RED cable to the POSITIVE
(+) terminal of each batlery taking care not to shod
against chassis.
, Connect one end of the BLACK cable to the NEGAo
TIVE (.) terminal ol fully charged battery.
o Connect the other end of the BLACK cable to good
CHASSIS GROUND_ away from fuel tank and batter},.
TO REMOVE CABLES REVERSE ORDER
BLACK cable first from chass s and then from the fuiy
, Repiace bulb n holder and push bulb holder securely
back into the hole n the backside of the grE
o Close hood.
INTERLOCKS AND RELAYS
[..BOSeor damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from sta4ing
Check wring See electricai wiring diagram n the
Repair Pads section of this manual
TO REPLACE FUSE
Replace with 30 amp automofive4ype plugo n fuse The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 30)
o Raise hood.
o Unsnap headlight wre connector.
" Stand in frent d tractor, Grasp hood at sides, t ftreward
engine and ft off of tracton
o To mp_ace reverse above procedures_
RED cabe last from both batteries
POSiTiVE TERMINAL NEGATIVE TERMINAL
CHARGED
BATTERY
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG, 30
FI_G,29