Filter
Top Products
CLEAN A_R SCREEN (See Fig, 15)
Ar screen must be kept free of dirt and chaff to prevent
engine damage from overheatin G C_ean with a wire brush
or compressed air to remove did and stubborn dded gum
fibers.
ENGINE COOLING FINS (See Fig, 17)
Remove any dust, di_ or oil frem engine cooling fns to
prevent engine damage from overheating°
o Remove screws from blower housing and iifl housing
and dipstick tube assembly off engine
o Cover oi{ fill opening to prevent entry d did
o Use compressed air or stiff br stle brush to tt_o_eugMy
clean engine cooiing fins_
To reassembie, reverse above pracedure
SCREWS BLOWER ROUSING
SPARK
PLUG
ENGINE COOUNG F_NS
F_G. 17
Inspect and replace co_roded muffter and spark arrester (f
equipped) as it could create a fire hazard and/or damage.
}N-LINE FUEL F}LTER (See Fig, 18)
The fueI %er shoud be replaced once each season. _ffuet
filter becomes clogged, obstructing fuel flow to carburetor,
replacement is required
, With engine coo_, remove fiiter and plug fuel Iine
sections.
Ptace new fuei fiiter in position in fuel Ine with arrew
pc nting towards carburetor
Be sure there are no rue! iine _eaks and c_amps are
properly positioned.
o Immediately wipe up any spilled gasoline
CLAMP
NG, 18
• Ciean engine, battery, seal finish, etc. of all foreign
matter_
o Keep finished sudaces and wheels free of all gasoline,
oil, elc_
o Protect painted sudaces with automotive type wax.
We do not recornmend using a garden hose to e_eanyour
tractor unless the eiectricaJ system, muffler, air filter and
carburetor are covered to keep wa£er ouL Water in engine
can result in a shodened engine ire.
SPARK PLUGS
first. Spark p_ug type and gap setting is shown in "PROD°
UCT SPECIFICATIONS" on page 3 of this manual
17