Filter
Top Products
TROUBLESHOOTING POINTS
PROBLEM
Engine continues to run
when operator leaves seat
with attachment clutch
engaged
Poor' cut - uneven
Mower blades will not
rotate
Poor grass discharge
Headlight(s) not working
(if so equipped)
_,_:_ ........ :--::7--7 .....
Battery will not charge
Engine "backfires"
when turning engine
"OFF"
CAUSE
1,_ Faulty operator-safety presence control system
1. Worn, bent or loose blade,
2 Mower deck not level
3 Buildup of grass, leaves, and trash under mower,
4, Bent blade mandrel,
5. Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels.
1, Obstruction in clutch mechanism,
2 Worn/damaged mower drive belt,
3 Frozen idter pu]iey
4 Frozen blade mandrel
1, Engine speed too slow,
2. Travel speed too fast
3 Wet grass
4 Mower deck not level.,
5, Lowluneven tire air pressure.
6, Worn, bent or loose blade,
7. Buildup of grass, leaves and trash under mower,
8 Mower drive belt worn,
9.. Blades improperly installed.
10, improper blades used,.
11 Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels,.
1. Switch is "OFF",.
2. Bulb(s) burned out..
3. Faulty light switch.
4 Loose or damaged widng,_
5, Blown fuse
t Bad battery ceil(s).
2 Poor cable connectiqns.
3, Faulty regulator (if so equipped),.
4 Faulty alternator,
1. Engine throttle control not set at "SLOW"
position for 30 seconds before stopping engine.
CORRECTION
1, Check wiring, switches and connections, If not
corrected, contact an authorized service center/
department.
1, Replace blade,. Tighten blade bolt
2. Level mower deck,
3,. Clean underside of mower housing,
4 Replace blade mandrel
5 Clean around mandrels to open vent holes,
1,. Remove obstruction,.
2. Replace mower drive belt,
3, Replace idler pufley
4. Replace blade mandrel_
1,, Place throttle control in"FAST" posilion.
2. Shift to slower speed.
3, Allow grass to dry before mowing,
4. Level mower deck.
5 Check tires for proper air pressure,
6 Replace/sharpen blade. Tighten blade bolt
7,. Clean underside of mower housing
8. Replace mower drive bell
9 Reinstall blades sharp edge down
10 Replace with blades listed in this manual.
1 Clean around mandrels to open vent holes,.
1. Turn switch "ON",
2. Repface bulb(s),
3, Check/replace light switch
4, Check wiring and connections
5. Replace fuse
1. Replace battery.
2, Check/clean atl connections,
3 Replace regulator,
4 Replace alternator,
Move throttle control to =SLOW" position and allow
to idle for 30 seconds before stopping engine,
26