Filter
Top Products
LY
iNSTALL NIULCHER PLATE (See Figs.7 A & ......
7B)
• Install two latch hooks to mulcher plate using screw,
washer', tookwasher, and weld nut as shown°
NOTE: Pre-assemble weld nut to latch hook by inserting
weld nut from the top with hook pointing down.
• Tighten hardware securely.
o Raise and hold deflector shield in upright position.
o Place front of mutcher plate over front of mower' deck
opening and slide into place, as shown_
° Hook front latch into hole on front of mower deck°
Hook rear latch into hole on back of mower deck.
CAUTION: Do not remove discharge
guard from mower. Raise and hold
guard when attaching muicher plate
and allow it to rest on plate while in
operation.
...... DEFLECTOR ......
.... SHIELD
LATCH
HOOKS
FIG. 7B
TO CONVERT TO BAGGING OR
DISCHARGING
Simply remove mulcher plate and store in a safe place.
Your mower is now ready for discharging or' installation of
c _tional grass catcher' accessory,
WELD NUT
FROM
HOOK POINTS
DOWN
LOCK
WELD. WASHER
NUT -'_
HOOK
HOOK
WASHER
MULCHER
PLATE
LOCK
WASHER
WELD
NUT
FIG. 7A
CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE
THE BEST PERFORMANCEAND SATISFACTION FROM
THIS QUALITY PRODUCT
PLEASE REVIEW THE FOLLOWING CHECKLIST:
#" All assembly instructions have been completed..
#" No remaining loose parts in carton.
J Battery" is properly prepared and charged° (Minimum
1 hour at 6 amps),.
v" Seat is adjusted comfortably and tightened securely.
#" All tires are properly inflated. (For' shipping purposes,
the tires were ovednflated at the factory).
,/ Be sure mower deck is properly leveled side-to-side/
front-to-rear for best cutting results. (Tires must be
properly inflated for leveting)o
,/ Check mower and drive beffs. Be sure they are routed
properly around pulleys and inside all belt keepers.
J" Check wiring. See that all connections are still secure
and wires are properfy clamped.
WHILELEARNING HOWTO USE YOUR TRACTOR, PAY
EXTRA A TTENTtON TO THE FOLLOWING IMPORTANT
ITEMS.:
v" Engine oil is at proper level
#" Fuel tank is filled with fresh, clean, regular unleaded
gasoline.
,/ Become familiar with all controls - their location and
function. Operate them before you start the engine.
J Be sure brake system is in safe operating condition_
10