Filter
Top Products
_ ......... 1 : ,, ,., :::...:: .... r_,:..... ,''1 ' . ;_._, _ '' ::"::................ ;_;,;; ......... : ...... " -- ,_;_;,_;,_
$ERVUCE ANDADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
= Depress clutch/brake peda| fully and set pa'rking brake, ........ .....
• Place gearshift lever in neutral (N) positron.
° Place attachment clutch in "DISENGAGED" position.
o Turn ignition key "OFF" and remove key.
o Make sure the blades and all moving parts have completely stopped.
° Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
TRACTOR
TO REMOVE MOWER (See Fig. 20)
Mower will be easier to remove from the right side oftractor_
o Place attachment clutch in "DISENGAGED" position.
o Move attachment lift lever forward to lower mower to its
towest position,
° Roll belt off engine puliey_
° Disconnect clutch rod from clutch lever by removing
retainer spring,.
. Disconnect anti-sway bar from chassis bracket by
removing retainer spnng_
° Disconnect suspension arms from rear deck brackets
by removing retainer springs.
= Disconnect front links from deck by removing retainer
springs°
° Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER iS TO BE MOUNTED TO THE TRACTOR, THE
R.H. AND L°H. SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR
TO INSTALL MOWER (See Fig. 20)
o Raise attachment lift lever to its highest position°
° Slide mower undertractorwith discharge guard to right
side of tractor_
° Lower lift lever to its lowest position..
= Install mower in reverse order of removal instructions_.
CLUTCH SPRING
SUSPENSION ENGINE
ARMS PULLEY
RETAINER
SPRING
ANTI-SWAY BAR
RETAINER
SPRINGS
(BOTH SIDES)
FIG. 20
SPRINGS
(BOTH SIDES
19