Filter
Top Products
i
i
MAINTENANCE
LAWN RIDER
Always observe safety rules when performing any mainte-
nance.
BRAKE OPERATION
If unit requires more than six (6) feet stopping distance at
high speed in highest gear, than brake must be adjusted.
(See "TO ADJUST BRAKE" in the Service and Adjust-
ments section of this manual).
TIRES
• Maintain proper air pressure in all tires (See "PROD-
UCT SPECIFICATIONS" on page 3 of this manual).
• Keep tires free of gasoline, oil, or insect control chemi-
cals which can harm rubber.
• Avoid stumps, stones, deep ruts, sharp objects and
other hazards that may cause tire damage.
BLADE CARE
For best results mower blades must be kept sharp. The
blades can be sharpened with a file oron a grinding wheel.
We suggest they be sharpened or replaced after every 25
hours of mowing. Check blades more often if mowing in
sandy conditions.
• Do not attempt to sharpen blades while they are on the
mower.
• Replace bent or damaged blades.
BLADE REMOVAL (See Fig. 13)
• Raise mower to highest position to allow access to
blades.
• Remove hex bolt,lock washer and flatwasher securing
blade.
• install new or resharpened blade with trailing edge up
towards deck as shown.
• Reassemble hex bolt, lock washer and flat washer in
exact order as shown.
• Tighten bolt securely (30-35 Ft. Lbs. torque).
IMPORTANT: BLADE BOLT IS GRADE 8 HEATTREATED.
'_ MANDREL
_ ASSEMBLY
/ .LADE
*A GRADE 8 HEAT TREATED BOLT CAN BE IDENTIFIED BY
SIX LINES ON THE BOLT HEAD.
TO SHARPEN BLADE (See Fig. 14)
Care should be taken to keep the blade balanced. An
unbalanced blade will cause excessive vibration and even-
tual damage to mower and engine.
• The blade can be sharpened witha file or on a grinding
wheel. Do not attempt to sharpen while on the mower.
• To check blade balance, you willneed a 5/8" diameter
steel bolt, pin, ora cone balancer. (When usinga cone
balancer, follow the instructions supplied with bal-
ancer).
• Slide blade onto an unthreaded portionofthe steel bolt
or pin and hold the bolt or pin parallel with the ground.
If blade is balanced, it should remain in a horizontal
position. If either end of the blade moves downward,
sharpen the heavy end until the blade is balanced.
NOTE: Do not use a nailfor balancing blade. The lobes of
the center hole may appear to be centered, but are not.
5/8"BOLT
OR PIN --
CENTER HOLE /j/
DE
FIG. 14
BATTERY (See Fig. 15)
Your unit has a battery charging system which issufficient
for normal use. However, periodic charging of the battery
with an automotive charger will extend its life.
• Acid solution level in each battery cell should be even
with bottomsofvent wells. Add onlydistilledor ironfree
water if necessary. Do not overfill.
• Keep battery and terminals clean.
• Keep battery bolts tight.
• Keep vent capstight and smallvent holes incaps open.
• Recharge at 6 amperes for 1 hour.
CUT AWAY VIEW
I I
WELL
FIG. 15
BATTERY
CELL ACID
LEVEL
FIG. 13 15