Filter
Top Products
SERVICE AND ADJUSTMENTS
TO REPLACE HEADLIGHT BULB
* Raise hood.
, Pull bulb holder out of the hole in the backside of the
grill.
= Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
, Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Check wiring, See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive4ype plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBL_
(See Fig, 26)
, Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at sides, tilt towarc
engine and lift off of tractor.
= To replace, reverse above procedures.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG, 26
23