Filter
Top Products
...... i i .... iiii¸ i, t n ,',1 n Iiu ii ,,i ...... w:-:-L ,Ji,,,,,,,11 i,, !
ASSEMBLY
n i i i i...................... ...... in i, I ,,i,n ,L , i ..............
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes_
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely,, Use
the correct too]s as necessary to insure proper tightness
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier° Standard
wrench sizes are listed,
(2) 7/16" wrenches Tire pressure gauge
(1) 1/2" wrench Utility knife
(1) 9/16" wrench
(1) 3/4" socket with drive ratchet
When right or left hand is mentioned in this manual, it
means when you are in the operating position (seated
behind the steering wheel)
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton (See page 6).
. Cut, from top to bottom, along lines on all four corners
of carton, and lay panels flat
• Remove mower and packing matedals
o Check for any additional loose parts or cartons and
remove_
BEFORE ROLLING TRACTOR OFF SKID
ATTACH STEERING WHEEL (See Fig. 1)
o Remove hex boit, lock washer and large flat washer
from steering shafL
• Position front wheels of the tractor so they are pointing
straight forward.
. Slide the steering sleeve over the steering shaft
o Position steering wheel so cross bars are horizontal
(left to right) and slide onto steering wheel adapter,
° Secure steering wheel to steering shaft with hex bolt,
lock washer and large flat washer previously removed.
Tighten securely,
o Snap steering wheel insert into center of steering
wheel.
. Remove protective plastic from tractor hood and grill,,
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES
iN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR
IS TO ROLL OFF SKID
i
STEERING
WHEEL
ADAPTER t_i_L_! //
// / STEERING
,_. _],/" /" SLEEVE .
/ t / /
I
t t i/ 1
FIG. I
TO ROLL TRACTOR OFF SKID (See Fig. 6)
. Raise attachment lift lever to its highest position_
- Release parking brake by depressing clutch/brake
pedal.
. Place gearshift lever in neutral (N) position.
- Roll tractor backwards off skid
7