Sears 552493 Chipper User Manual


  Open as PDF
of 28
 
12
33.Assemblethehoseadapter(nozzle)tothefrontof
the impeller housing and secure with the three knobs.
Make sure that the switch actuator bracket contacts
theswitchonthehousing.Seegure19.
FIGURE 22
FIGURE 20
34. Place a hose clamp onto one end of hose. Push hose
ontohoseadapter(nozzle).Tightenhoseclamponto
hose and hose adapter. Do not collapse hose adapter
whentighteningclamp.Seegure20.
35. Place the hose hanger rod assembly into the hose
hanger bracket on the impeller housing assembly.
Seegure20.
36. Loop the 25" tarp strap under the hose. Hook to the
hosehangerrodassembly.Seegure20.
FIGURE 19
HOSE ADAPTER
(NOZZLE)
KNOB
SWITCH
ACTUATOR
BRACKET
39. Assemble the hitch plate to the tractor hitch if:
a. Your tractor has a square (straight) hitch frame,
to help prevent binding.
b. Your tractor has a lightweight hitch frame that
needs reinforcing for towing the Chip-N-Vac.
Usea1/2"x1-1/4"hexbolt,a7/16"atwasheranda
1/2"nylocknut.Seegure22.
TRACTOR
HITCH FRAME
(SQUARE)
HITCH
PLATE
TRACTOR
HITCH FRAME
(TAPERED)
1/2" x 1-1/4"
HEX BOLT
7/16" FLAT WASHER
1/2" NYLOCK NUT
ATTACH
MOW-N-VAC
HERE
FIGURE 21
5/16" FLAT
WASHER
CHIPPER CHUTE
ASSEMBLY
5/16"
NYLOCK
NUT
HOSE HANGER
ASSEMBLY
25" TARP
STRAP
HOSE ADAPTER
(NOZZLE)
HOSE
CLAMP
HINT: Tip the cart bed back for easier access in the next
paragraph.
37. Attach the chipper chute assembly to the weld bolts
on the back side of the impeller housing using three
5/16"atwashersand5/16"Nylocknuts.Tighten.
Seegure21.
38. Insert the tamper plug into the end of the chipper
chute assembly.
 previous next