Sears 552493 Chipper User Manual


  Open as PDF
of 28
 
10
FIGURE 11
20.Placeasidepanelontopofthecartbedange,
inside the lip of the front panel. Fasten the side panel
to the front panel using three 1/4" x 5/8" hex bolts
and 1/4" nylock nuts. Fasten the side panel to the cart
bedangeusingtwo1/4"x5/8"hexbolts,1/4"at
washers and 1/4" nylock nuts. Tighten.Seegure11.
Repeat on other side.
FIGURE 12
21. Screw a 1/4" hex nut approximately half an inch onto
a 1/4" x 1" hex bolt. Insert the bolt into the hole shown
ingure12,inthesideofthecart.Fastentheboltto
the cart using a 1/4" nylock nut. Tightenso that the
nutisushwiththeendofthebolt.Repeatonthe
otherside.Seegure12.
22. Assemble the cross brace to the top rear holes in the
side panels using four 1/4" x 5/8" hex bolts and 1/4"
nylocknuts.Seegure12.
23. Assemble a door latch at each end of the cross brace
using a 5/16" x 3/4" hex bolt, a nylon washer and a
5/16" nylock nut. Place the nylon washer between the
door latch and cross brace. Tighten so that latch is
snugbutwillstillrotate.Seegure13.
FIGURE 13
24. Install the poly hard top using fourteen 1/4" x 3/4"
hexboltsand1/4"atwashersontheoutsideand
fourteen1/4"atwashersand1/4"nylocknutsonthe
inside. Tighten.Seegure14.
FIGURE 14
1/4"x5/8"
HEX BOLT
1/4" FLAT
WASHER
1/4" NYLOCK NUT
1/4" NYLOCK NUT
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK NUT
1/4" HEX NUT
1/4" x 5/8"
HEX BOLT
CROSS
BRACE
1/4" NYLOCK NUT
1/4" x 1"
HEX BOLT
5/16" x 3/4"
HEX BOLT
CROSS
BRACE
DOOR
LATCH
NYLON
WASHER
5/16" NYLOCK NUT
1/4" x 3/4"
HEX BOLT
1/4" FLAT
WASHER
1/4" NYLOCK NUT
POLY HARD TOP
1/4" FLAT
WASHER
 previous next