Filter
Top Products
PREPARING YOUR SAW FOR USE
A. GEEING READY
1. READ YOUR 0PERATOWS MANUAL
CAREFULLY'" .....
._......Your Operators; Manual has been developed to
i _ help you,prepare your saw for use and to under-
• Stand its safe operation. It is;important that you
read your manual completely to become familiar
with the unitbeforeyou beginassembly.
• , ,, H,,
B. ATTACHINGTHE HANDGUARD
The Handguard is a protective device designed
to hetp prevent your hand from coming in con-
tact with the cutting chain should your hand slip
off the handlebar, tt will not:eliminate the
possibility of injury from kickback or toss of con-
_trol of.the saw. .........
2. HAVE THE FOLLOWING AVAILABLE:
a. Protective gloves _-.....'
b; Approved, marked fuel container
c. One gallon leaded or unleaded, regular
gasoline • • : _ :_'
d. Bar and Chain Lubricant (see page 9).
e. Scrench--provided with your unit. No other
. tool is necessary for assembly. The long
end of the too! can be used as a slotted
screwdriver. The small PiPe end canbe us-
WARNING! .......
Do not use the saw without the handguard in
place. ,
• Lift and carry the chain saw by the handlebar
or rear handle, not by the handguard.
• Keep the handguard securely fastened at all
times. Check the handguard screws each
time the saw is used. ....
CAP HANDGUARD HANDLE
.... : :i:" ::-iFigure 1 :_ ?_ _
C. ATTACHING THE SPUR
The spur is a special piece,of equipment de-
signed to assist the cutting operation. When
assembled to the saw, the spur. will dig into the
tree or log and: _i ....
--relieve contact pressure adding"ease to the
sawing operation.
--allow the saw to be more easily rotated or
pivoted into the cut.
To install:
1. Alignthe Handguard and Handguard Cap
around the handlebar as shownin Figure 1.
2. Fit the imounting pin on the Handguard into
the hole in the handlebar. Figure 1.
3. Insert the 3 mounting screws into the 3 holes
on the Handguard Cap.
4. Turn .each screw a little at a time clockwise,
until the Handguard Cap and Handguard
meet and there is no gap between the two
parts.
BAR
CLAMP. (
BAR NUTS
GUIDE BAR PLATES
Figure 2
To Install:
1. Remove Bar Clamp Nuts, Bar Clamp and
Guide Bar Plates.
2. Align the spur over the two holes on the bar
clamp side of the saw. Figure 2.
3. Insert the two screws and tighten evenly and
securely.
i,,i