Filter
Top Products
Storing Machine - 27
STORING MACHINE
Storing Machine
Storing Safety
Preparing Machine for Storage
1. Repair any worn or damaged parts. Replace parts if
necessary. Tighten loose hardware.
2. Clean under the deck.
3. Sharpen mower blades.
4. Paint scratched or chipped metal surfaces to prevent
rust.
5. Apply light coat of engine oil to pivot and wear points to
prevent rust.
6. Lubricate grease points.
Preparing Fuel and Engine For Storage
Fuel:
Ifyouhavebeenusing“Stabilized Fuel”, add stabilized fuel
to tank until the tank is full.
NOTE: Filling the fuel tank reduces the amount of air in
the fuel tank and helps reduce deterioration of fuel.
If you are not using “Stabilized Fuel”:
1. Stop mower in a well-ventilated area.
NOTE: Try to anticipate the last time the mower will be
used for the season so very little fuel is left in the fuel
tank.
2. Allow engine to run until it runs out of fuel.
3. Change engine oil and filter while engine is warm.
4. Mix fresh fuel and fuel stabilizer in separate container.
Follow stabilizer instructions for mixing.
5. Fill fuel tank with stabilized fuel.
6. Run engine for a few minutes to allow fuel mixture to
circulate through carburetor.
Engine:
Engine storage procedure should be used when mower is
not to be used for longer than 60 days.
1. Service air filter if necessary.
2. Clean debris from engine air intake screen.
3. Removesparkplug.Put30mL(1oz.)ofcleanengine
oil in cylinder.
4. Install spark plug, but do not connect spark plug wire.
5. Slowly pull starter handle several times to allow oil to be
distributed.
6. Store the mower in a dry, protected place. If mower is
stored outside, put a waterproof cover over it.
Fold Handles
1. Remove grass bag and bagging chute if installed.
2. Remove starter handle (A) from rope guide.
cCAUTION: Avoid injury! Engine exhaust fumes
can cause sickness or death.
• If it is necessary to run an engine in an
enclosed area, use an exhaust pipe extension
to remove the fumes. Always try to work in a
well ventilated area.
• DONOTstoremowerwithfuelinthetank
inside a building where fumes may reach an
open flame or spark.
• Allow engine to cool before storing in any
enclosure.
IMPORTANT: Avoid damage! Fuel without stabilizer
can varnish and partially plug carburetor jets and
passageways in a stored machine.
• Use fresh fuel when adding fuel stabilizer. Fuel
stabilizers are ineffective when added to fuels that
aremorethan30daysold.
IMPORTANT: Avoid damage! DO NOT CRIMP
CABLES when folding handle bars.
A
M87088