Filter
Top Products
Service - 22
SERVICE
raised position.
2. Remove plastic hubcaps (A).
• Use a screwdriver in slot (B) to pry the hubcap from
each wheel.
3. Remove locknut (C) and washer (D).
4. Remove wheel from each axle.
5. Apply a light coating of grease to each axle (E).
6. Install wheels, hardware and hubcaps.
7. Lower mower.
8. Repeat procedure on other side of mower.
Check Blade
NOTE: Sharpened edges on blade tips must face
upward when installing blade.
CHECK BLADE:
• Replace damaged blade.
• Tighten Bolt (A) to 75 N•m(55lb-ft).
• Sharpen dull blade. (See Sharpening Blade in this
section.)
TO REMOVE BLADE:
• Remove bolt (A), washer (B), and blade.
Sharpening Blade
Sharpen blade with grinder, hand file or electric blade
M93049
A
B
M93051
C
D
E
M93050
cCAUTION: Avoid injury! Service blade safely:
• STOP engine. Let it cool.
• Disconnect spark plug wire.
• Wear gloves or wrap blade with a rag.
IMPORTANT: Avoid damage!
Turn mower on its LEFT SIDE to help prevent air
cleaner damage and hard starting.
cCAUTION: Avoid injury! Wear gloves and
goggles when sharpening, balancing or
installing blade.
IMPORTANT: Avoid damage! Balance blade after
you sharpen it. An unbalanced blade may cause
excessive vibration.
M87085
B
A